Programming Sequence - Erreka DINGO Manuel De L'installateur

3

PROGRAMMING SEQUENCE

General navigation through the programming parameters and menus
Display
off ENTER
á
or
ESC
showing
à
CL

Before entering the programming menus, it is
necessary to close the gate or disconnect the device
and then reconnect.

Press the ENTER button to access the programming
menus.
The display shows "C"1 01 or "C"1 0 2.

Use the keys ^ and to select the required values,
V
and confirm by pressing ENTER.

Use ESC to go back to the previous display.

To leave the programming menu, press ESC several
times until the display goes off or shows CL.
Initial Conditions Programming (D1= "C")
1 Press ENTER to access the programming menus. The
display lights up and D1 flashes.
2 Press the buttons ^ and
C C flashing. Press ENTER to confirm. D2 flashes.
D1 D2 Parameter
C 1 Motor turning direction
4
Opening safety device (photocell
or strip)
5
Closing safety device (photocell
or strip)
D1
ENTER
á
C
ESC
à
Select the value
using ^ and
V
until D1 shows the letter
V
D3 D4
0 1
0 2
0 0
1 0
1 1
0 0
1 0
1 1
START UP AND PROGRAMMING
D2
ENTER
á
1
ENTER
(confirming)
à
Select the value
using ^ and
ESC
V
(unconfirmed)
à
1 Programme the prior conditions (see "Initial
Conditions Programming (D1= "C")" on page 55).
2 Programme the pedestrian and total opening radio
codes, along with the gate open/close (see "Radio
code programming (only with RSD) and gate open/
close programming (D1= "P")" on page 56).
3 Programme the functioning mode, automatic
standby time and pedestrian opening (see "Main
Functions Programming (D1= "F")" on page 56).
4 Programme the advanced functions (see "Advanced
Functions Programming (D1= "A")" on page 57).
3 Press the buttons ^ and
parameter appears. Press ENTER to confirm. D3 and
D4 flash.
4 Press the buttons ^ and
D4 value appears (see chart). Press ENTER to
confirm.
5 Press ESC to return to the previous display.
Default
Options
option
x
x Device not installed
Device without testing
Device with testing
x Device not installed
Device without testing
Device with testing
D3 - D4
0 X
Select the value using
^ and
V
until the required D2
V
until the required D3 and
V
DINGO operator for sliding gates
55