Description Of The Product; Elements Of The Complete Installation - Erreka DINGO Manuel De L'installateur

DESCRIPTION OF THE PRODUCT

1

ELEMENTS OF THE COMPLETE INSTALLATION

1 Gate
2 Rack
3 Lower track and guide wheels
4 Upper guide
5 Operator with control panel
6 Magnetic key or proximity key reader
7 Wall pushbutton/key switch
8 Photocells
ELECTRICAL WIRING:
Element
A: Main power supply
B: Flashing light
C: Photocells (Tx / Rx)
D: Pushbutton/wall key
E: Antenna
Fig. 1 Elements of the complete installation

The safe and correct operation of the
installation is the responsibility of the installer.
9 Mechanical strip
10 Identification plate
11 Traffic light
12 Flashing light with antenna
13 Gate stopper
Nº wires x section
2
3x1.5mm
2
2x0.5 mm
2 2
2x0.5 mm / 4x0.5 mm
2
2x0.5 mm
Screened cable

For greater safety, Erreka recommends installing
photocells (9) and strips (10).
E275A
Maximum length
30 m
20m
30m
50m
5m
DINGO operator for sliding gates
English
43