Eaton Powerware 9125 Guide D'installation page 21

4. Using two clip nuts and two hex-head screws, attach the rail to the
rear of the rack (see Figure 4 and Figure 5).
The bottom rail uses positions 2 and 4 for the rear hex-head
screws. If you are installing additional rails, the next rail should be
placed 7 holes above the last installed screw.
®
EATON Powerware 9125 (9910-P64) UPS Installation Guide for IBM
Position 13
Position 11
Position 4
Position 2
Figure 4. Rear Rack Screw Positions
Figure 5. Securing the Rear of the Rail
® S
Applications
INSTALLATION
Second Rail
First Rail
Clip Nuts
7
164201637 Rev A