Setup And Installation; Rack-Mount Setup - Eaton Powerware 9125 Guide D'installation

Setup and Installation

The Powerware 9125 UPS is designed for flexible configurations and can
be installed in a rack or as a standalone cabinet.
If you are installing the UPS in a rack, continue to the following section
"Rack-Mount Setup;" otherwise, continue to "Tower Setup" on
page 4.

Rack-Mount Setup

The UPS can be installed in 19- or 23-inch racks and needs only 2U of
valuable rack space.
NOTE Fixed mounting rails are required for each UPS and EBM cabinet. If fixed rails are
not already installed in your rack, contact your local IBM representative to order a rail kit(s). If
you are installing the UPS in a non-IBM rack, contact your Powerware representative.
To install the UPS in a rack:
1.
2.
3.
4.
®
EATON Powerware 9125 (9910-P10, P11, P15, P16) UPS Installation Guide for IBM
Place the UPS on a flat, stable surface with the front of the UPS
facing toward you.
Attach the supplied mounting handles to the mounting brackets and
secure with the supplied screws (see Figure 4).
Align the mounting brackets with the screw holes on the side of the
UPS and secure with the supplied screws (see Figure 4).
If installing optional Extended Battery Modules (EBMs), repeat
Steps 1 through 3 for each cabinet.
Mounting
Handle
Figure 4. Installing the Mounting Brackets
INSTALLATION
Mounting
Bracket
® S
Applications 164201633 Rev A
3