Fracarro FRPRO10HD Instructions D'emploi page 37

Notes
• Once activated the cluster is associated to the UHF input you are programming. To change the cluster-
input association, select the INPUT item from the cluster menu.
• All clusters are off by default. To enable the cluster, set the channel type (analog or digital).
Follow the instructions above to program all clusters.
Clusters associated to other inputs
The clusters can be associated to three inputs UHF1, UHF2 or UHF3 by means of a fl exible matrix; therefore,
it is possible to see the settings of the cells associated to other inputs by entering the menu of a UHF input.
UHF3 input menu
Cluster associated
to input UHF2
By selecting the cluster shown in the previous fi gure and pressing the
the cluster. The settings are displayed as shown in the following menu:
Cluster number 6
Start channel cluster
5.3.2 PROGRAMMING THE B.III+DAB+FM
For the B.III+DAB+FM, input, it is possible to regulate the gain from 0 to 20dB by entering the INPUT SET-
TINGS menu and selecting the item B.III+FM. Use the Up/down arrows to change the set value and conform TINGS menu and selecting the item B.III+FM. Use the Up/down arrows to change the set value and conform
by the key .
CELLA 1 - UHF 3
E21 : E21 - OFF
Start channel cluster
UHF 3 E33 - E37
<DDDDD22112> 06
CELLA 6 - UHF 3
E33 : E37 -
End channel cluster
Cluster Off
End channel cluster
Indication of the number of
clusters you are programming
key, you can enter the settings of
Input UHF3
Cluster associated
2
to input UHF2
37