Fracarro FRPRO10HD Instructions D'emploi page 26

UHF3 *
2.2 CLUSTER DESCRIPTION
Programming defines the clusters by setting the initial channel and the end channel, channel type (analog or
digital), the gain and UHF associated input. Each cluster can comprise of minimum 1 channel to maximum 6
adjacent channels; the clusters that are not used need to be switched off. The clusters are associated with
the UHF inputs by means of a flexible matrix.
The sharing matrix of clusters/UHF inputs is defined as follows:
UHF 1
CLUSTER CLUSTER
10
Fig. 2.2 - Sharing of the clusters (channel groups) for the UHF1, UHF2 and UHF3 inputs.
Up to 10 clusters can be associated with the UHF 3 input.
Up to 6 clusters can be associated with the UHF 2 input (from the cluster 5 to cluster 10).
Up to 3 clusters can be associated with the UHF 1 input (from the cluster 8 to cluster 10).
The association of the clusters to the UHF input is made during the programming from the keyboard or PC
programming software.
UHF1
UHF2
CLUSTER CLUSTER
9 8 7
LED to show remote power supply. When the
LED is ON (red), it means that the power is
activated for that input. The power supply can
be selected by means of programming (12V or
24V).
UHF 2
CLUSTER CLUSTER CLUSTER
6 5 4
OUT RF
26
UHF 3
CLUSTER CLUSTER CLUSTER
3 2 1