Fracarro FRPRO10HD Instructions D'emploi page 31

From the initial menu, 5 sub-programming items are available:
Insert PIN
Setting cluster input parametres
Power supply UHF1-UH2-UHF3
CONTROL UNIT settings: the main functions of this menu are language selection, management of the ac-
cess PIN, loading/saving the file from the USB pen drive and resetting the unit to the factory settings.
INPUT settings: the main functions of this menu are the definition and programming of UHF clusters and
the B.III+DAB+FM input gain.
SELF-ALIGNEMENT settings: : the function of this menu is to enable the self-alignment of the gains in or-
der to automatically equalize the clusters, guaranteeing the best noise figure and the maximum output level
Settings the FINAL GAIN: the function of this menu is to program the final gain to increase/decrease the
level of all amplified signals after the self-alignment.
Setting REMOTE POWER SUPPLY: the function of this menu is to remotely manage the feed of the UHF
inputs (independently).
5.1 INITIAL MENU
Setting headend parametres
FRACARRO
FRPRO10HD
Enter Code
Setting and start the gain
self-aligning
Gain self-aligning start
(onecycle)
Turn off/turn on the input
POWER SUPPLY
SETTINGS
CONTROL UNIT
SETTINGS
INPUT
SETTINGS
SELF ALIGNING
SETTINGS
MASTER GAIN
SETTINGS
31
CHAPTER
5.2
CHAPTER
5.3
CHAPTER
5.4
CHAPTER
5.5
CHAPTER
5.5