Fracarro FRPRO10HD Instructions D'emploi page 36

Enter the "INPUT SETTING" menu and use the up/down arrows to move along the menu abnd select the
UHF Input to program. The following will appear:
ATTENTION: the following instructions are based on the UHF 3 input because it is the most fl exible
and allows programming all clusters.
Indication of input being pro-
gramming
D: cluster with digital channels;
A: cluster with analog channels;
X: cluster off;
_: cluster cannot be selected for this input UHF
E: cluster in Error (possible overlapping of channels with other clusters);
If the cluster is associated to a UHF input that is different from the input you are programming:
1: cluster associated to the UHF1 input;
2: cluster associated to the UHF2 input;
3: cluster associated to the UHF3 input;
Use the left/right arrows to select the cluster to program:
Start channel cluster
The select cluster fl ashes
The selected cluster will fl ash. Press the
menu:
Number cluster 1
Starting channel clusters
Press the key again to enter the setting of the cluster's initial channel and end channel.
The cluster's initial channel fl ashes, use the up/down arrows or the digit keyboard to enter/select the channel The cluster's initial channel fl ashes, use the up/down arrows or the digit keyboard to enter/select the channel
number. Press key to confi rm and then set the cluster's end channel. The cluster's end channel fl ashes, key to confi rm and then set the cluster's end channel. The cluster's end channel fl ashes,
use the up/down arrows or the digit keyboard to enter/select the cluster's end channel. Press the key
confi rm the confi guration.
Using the up/down arrows, the clusters can be enabled:
• setting the channel type (analog, digital, OFF),
• regulating the cell gain (if enabled),
• setting the association of the cluster to the UHF input
•
UHF 3
<XXXXXXXXXX> --
Indication the clusters of FRPRO10HD
UHF 3 E21 - E21
<DDDDDDDDDD> 01
key to enter the cluster programming and display the following
CELLA 1 - UHF 3
E21 : E21 -
End channel clusters
36
Channel end Cluster
only if the cluster is actived
Cluster number
UHF3 aerial input
association to the cell 1
Channel type:
DTT: Digital
DTT
A: Analog
OFF: cluster off
* There is this indication
to