Installing Type R - Knick 830 R Mode D'emploi

4.3

Installing Type R

Attaching the Symbol Label
Before installing the indicator, you should
attach the selected symbol label.
(See "Accessories" on page E-122.)
• Pull off the selected label.
• Stick the label onto the square on the
rating plate (see Fig. 5.6).
Fastening the Indicator
The following is required for mounting the
indicator:
• 1 screwdriver
• 2 screws (e.g., M4 EN ISO 1207,
not included)
Proceed as follows:
• Loosen the 4 cover screws
and take off the cover.
• Insert a screw (e.g., M4 EN ISO 1207)
through each of the 2 mounting holes
and tighten them to fasten the device.
• Screw the cover to the housing.
CAUTION!
Protect against ESD when the cover is
open!
E-85