Knick 830 R Mode D'emploi page 110

Setting the Min/Max Contacts
• Set the contact as n/c (normally closed).
The small flashing display shows the
currently active setting
• Set the contact as n/o (normally open).
• Change the setting in the large display.
• Confirm change.
The next time the menu is opened, the
setting appears in the small display.
Setting the Display Flashing
• Set display flashing Y FL (flashing on) or
no FL (flashing off ).
With Y FL, the measured value flashes
when the set limit value (setpoint) is
exceeded.
With no FL, flashing in the case of limit
violation is suppressed.
• Edit display flashing.
• Confirm change.
E-110