Knick 830 R Mode D'emploi page 100

E-100
When the measured value falls below or
exceeds the setpoint but is still within the
hysteresis range, hyst is displayed.
When the measured value falls below or
exceeds setpoint plus hysteresis, flashing
stops and the min/max output switches
back.
The switches are floating, polarized semi-
conductor switches
• The semiconductor switches block at
input currents < 0.3 mA or < 3.8 mA,
resp., or > approx. 24 mA.
• Voltage drop when switched:
approx. 0.5 V
• During parameter setting the min/max
outputs states are frozen.