EdilKamin MYA Air Tight Installation, Usage Et Maintenance page 29

fig. 1
A
fig. 3
C
E
fig. 5
H
X
X
fig. 7
INSTALLATION
fig. 2
B
D
fig. 4
G
F
G
fig. 6
I
fig. 8
3) FLUE OUTLET AT THE TOP
MYA is set up to allow the flue pipe to be connected at the top
or the back.
The stove is delivered ready for the flue pipe to be fitted at the
back.
To allow the flue pipe to be connected at the top, the specific
optional extra kit must be used (code
760680). The kit includes the following parts:
- N° 1 80 Ø clamp (L)
- N° 1 inspection elbow (M)
- N° 1 flue pipe outlet (P)
- N° 2 top flue pipe outlet closers (Q)
To fit the kit, proceed as follows:
For the version with glass sides
- Remove the supported glass top (A - fig. 1).
- Open the door and remove the galvanised panel (B - fig. 2)
- Slacken the wing nuts at the lower and upper ends on the
inside of the left side (C/D -fig. 3/4).
- Close the door and remove the plating profiles on the back
(E - fig. 5).
- Remove the glass side (F - fig. 6) removing the clamps (G -
fig. 6).
- Then proceed to fit the kit as indicated on the next page.
For the version with steel sides
- Remove the supported glass top (H - fig. 7).
- Remove the side steel, fixed to the structure of the stove with
2 screws (X - Fig. 7) to remove, pulling it upwards (I - Fig. 8)
- Then proceed to fit the kit as indicated on the next page.
- 29
-