Adjusting The Turn Signal; Storage; Cleaning And Care; Troubleshooting - Gazzini 10030302 Mode D'emploi

²
12
= 7.46
19.3
A 7.5 ohm resistor is required (not included).
The resistors are available partly pre-wired, so they are very easy to install, and it
is impossible to connect them incorrectly.
You must pay attention to the load range for which universal flashers are
intended to be used and whether there are one or two turn signal indicator lights
on the vehicle. If there is only one common turn signal indicator light for the
right-hand and left-hand flasher, one hazard warning flasher or one acoustic turn
signal monitor, it may be simpler to work with resistors.
CAUTION!
Risk of accident!
It is imperative that you bear in mind that when electronic flasher
relays are used, the failure of a turn signal is no longer indicated
by the indicator light, which could put you at risk of an accident.
You should therefore check that your turn signals are fully
functional before the start of every journey.

4.5 | Adjusting the turn signal

Horizontal
20°
80°
At an attachment height of < 750 mm the lower angle can be reduced to 5°.
The turn signal, i.e. mirror, must be aligned as per the diagram in order to ensure
proper emission and a good view of the road behind you at the same time.
22
Vertical
15°
15°

5 | Storage

Before the gazzini Mirrors are installed, store them in the original packaging in a
place that is protected from weather and moisture.

6 | Cleaning and care

Clean the gazzini Mirror using warm soapy water or a motorcycle cleaner and a
soft cloth. Do not use a high-pressure cleaner as it may destroy the seals, and
water may get into the gazzini Mirror or turn signal. Afterwards, use a wax-based
care product which will protect the surface against the elements. Do not apply
the care product to the turn signal or the mirror.

7 | Troubleshooting

Fault
Possible causes and remedies
The turn signal does not It is possible that the positive/negative cables are
light up. wrongly connected. Check that positive is connected
to positive and negative to negative. The battery
voltage may be too low for the turn signals to
function. Check the battery voltage.
The turn signals flash
A load-independent relay must be installed because
too fast or too slow.
the output power of the original turn signal is not the
same as that of the new turn signal. If a relay cannot
be installed, resistors must be used instead. (See
chapter 4.4 Electrical connection).

8 | Warranty

This product comes with the statutory two-year warranty. The warranty period
begins on the date of purchase. It does not cover normal wear and tear, use for
anything other than the intended purpose, or damage caused by an accident,
tampering or attempted repairs by unauthorised persons or customer service
departments.
23