Scope Of Delivery; General Information; Reading And Keeping The Instructions For Use; Explanation Of Symbols - Gazzini 10039294 Mode D'emploi

HANDLEBAR MIRRORS

1 | Scope of delivery

Art. No. 10039294
1
2 3
Art. No. 10039295
2 3 4
10
mirror housing incl. mirror arm with
1
M10 x 1.25 right-hand thread
thread adapter M10 x 1.25 right-hand
2
thread
thread adapter M10 x 1.5 right-hand
3
thread
4 rubber cap
4
mirror housing incl. mirror arm with
1
M10 x 1.25 right-hand thread
thread adapter M10 x 1.25 left-hand
2
thread
1
thread adapter M10 x 1.5 left-hand
3
thread
4 rubber cap

2 | General information

2.1 | Reading and keeping the instructions for use

These instructions for use apply exclusively to the aforementioned gazzini Bar-end
Mirrors (for short: mirrors). They contain important information on installation,
safety and the warranty. Read these instructions carefully, in particular the safety
instructions, before using the mirror. Failure to follow the instructions can result in
damage to the mirror itself or to your motorcycle, make it less safe to ride on the
road, and possibly cause consequential damage. Keep these instructions for future
reference. If you pass the mirror on to a third party, you must also hand over these
instructions. The instructions for use are based on the standards and regulations
applicable in the European Union and reflect current state-of-the-art technology. If
abroad, you should also observe any country-specific guidelines and laws.

2.2 | Explanation of symbols

The following symbols and signal words are used in these instructions.
This symbol/signal word indicates a hazard with a
WARNING! medium risk level which, if not avoided, may result in
death or serious injury.
This symbol/signal word indicates a hazard with a low
CAUTION! risk level which, if not avoided, may result in minor or
moderate injury.
IMPORTANT! This signal word warns of possible material damage.
This symbol indicates useful additional information
about assembly or usage.
This symbol indicates that the packaging and product
can be recycled.

3 | Safety

3.1 | Intended use

The gazzini Handlebar Mirror is intended as a replacement for a defective original
mirror or to enhance the look of your motorcycle. The mirror is not designed for a
specific type of vehicle.
It comes with various adapters for installing on many different motorcycles. The
mirror is E-approved and can be used legally in road traffic in member states of the
11