General Information; Scope Of Delivery - Gazzini 10028737 Instructions De Montage

GB |
TRANSLATION OF ORIGINAL INSTRUCTIONS FOR INSTALLATION AND USE
HANDLEBAR ENDS 3 IN 1
(Order no. 10028737 and 10028738)
These instructions for installation and use apply exclusively to the products described. They contain
important information on installation, safety and warranty. These instructions should always be
observed, even if you pass the product on to third parties. Keep them in a safe place so that you
can refer to them again later.

1 | GENERAL INFORMATION

The gazzini handlebar ends are used to give an optical finish to open-ended tubular handlebars
(without threaded inserts or similar) with an outer diameter of 22 mm (metric) and 25.4 mm
(imperial), and a minimum inside diameter of 13.5 mm. To ensure that you use these components
correctly and safely, please observe the installation and safety Instructions.

2 | SCOPE OF DELIVERY:

Order no. 10028737
1|
2x short handlebar ends
1
2x countersunk screws with hex socket
2
DIN 7991 M6 x 45 A2
2x hex nuts with flange
3
DIN 6923 M6 A2
2| 3| 4| 5|
2x rubber bushings 20 x D18/d6
4
2x rubber bushings 20 x D14/d6
5
2x rubber bushings 20 x D12/d6
6
2x caps (self-adhesive)
7
6| 7|
9