Electrical Conection; Putting Into Operation; Maintenance And Troubleshooting - T.I.P. Maxima 350 IPX DUO Mode D'emploi

6. Electrical conection

The unit is equipped with a mains connection cable and a mains plug. It must only be
replaced by qualified staff to avoid any danger. Please do not use the mains connection
cable to carry the pump, and do not use this cable to pull off the plug from the socket, either.
Protect the mains connection cable and mains plug from heat, oil or sharp edges.
The values stated in the technical details have to correspond to the mains
voltage. The person responsible for the installation has to make sure that the
electrical connection is earthed in compliance with the applicable standards.
The electrical connection has to be equipped with a highly sensitive residual
current circuit-breaker (FI switch): ∆ = 30 mA (DIN VDE 0100-739).
If extension cables are used, their cross-section must not be smaller than
that of rubber-sheathed cables of the H07RN-F (3 x 1,0 mm²) short code.
The mains socket and the plug-and-socket elements have to be in
splashwater-proof design.

7. Putting into operation

Nobody must be in the water while the pump is running.
The pump must only be operated in the performance range indicated on the
type plate.
Dry-running - i.e., operating the pump without discharging water - is to be
avoided since the absence of water may cause the pump to run hot. This
may cause considerable damage on the device.
Please make sure that the electrical plug connections are in the flood-proof
area.
As long as the device is connected to the electrical mains, one must never
reach with one's hands into the opening of the pump.
Please inspect the pump visually prior to each use. This applies in particular to the mains
connection line and the mains plug. Make sure that all screws are firmly tightened, and verify
the perfect condition of all connections. A damaged pump must not be used. In any case of
damage, the pump has to be inspected by qualified service staff.
Each time the pump is put into operation, please make sure that the pump is set up securely
and firmly standing.
To put the unit into operation, please plug the mains plugs into a 230V AC socket. If the
water level has reached or exceeded the cut-in level, the pump will start to run immediately.
To stop the operation of the pump, please pull the mains plug off the socket.
The electrical pumps of the T.I.P. TSX series are equipped with an integrated thermal motor
protection feature. In the case of overload, the motor will switch off independently and on
again after cooling down. For possible causes and their elimination, please refer to the
"Maintenance and troubleshooting" section.

8. Maintenance and troubleshooting

Prior to carrying out any maintenance work, the pump must be separated
from the electrical mains. If you fail to separate the unit from mains, there is a
risk of an inadvertent start of the pump.
18
7