T.I.P. Maxima 350 IPX DUO Mode D'emploi page 19

3. Pull the inner plastic pump base evenly on both sides from inside to outside of the
stainless steel casing until it stops.
4. Secure the pump foot by turning it 20 ° counterclockwise and lock it in place by hooking
Figure 3.
the lock onto the locking pin as shown in
Fig. 3
5. Now the pump can be used for dirty water operation
6. To use the pump in clear water operation (flat suction), you must unlock the
fuse with the pump upside down (Fig. 4) and turn the moving part of the pump
base by 20 ° to the right (clockwise) as described above. Now the plastic pump
foot can be pushed back completely into the stainless steel jacket and is thus
prepared for the flat suction
Fig. 4
17
6