Body Posture During Measurement; Taking Your Blood Pressure Reading - Gima KD-595 Manuel De L'utilisateur

Note:
1. please refer to the cuff circumference range in "SpECIfICatIonS"
to make sure that the appropriate cuff is used.
2. measuring on same arm each time.
3. Do not move your arm, body, or the monitor and do not move the rubber
tube during measurement.
4. Stay quiet, calm for 5 minutes before blood pressure measurement.
5. please keep the cuff clean. If the cuff becomes dirty, remove it from
the monitor and clear it by hand in a mild detergent, then rinse
it thoroughly in cold water. never dry the cuff in clothes dryer or iron it.
Clean the cuff after the usage of every 200 times is recommended.
6. Do not place the cuff around your arm if the arm has any inflammation,
acute diseases, infections skin wounds.

6. Body posture during measurement

Sitting Comfortably Measurement
a. be seated with your feet flat on the floor,
and don't cross your legs.
b. place palm upside in front of you on a flat surface
such as a desk or table
c. the middle of the cuff should be at the level
of the right atrium of the heart.
Lying Down Measurement
a. Lie on your back.
b. place your arm straight along your side with your
palm upside.
c. the cuff should be placed at the same level
as your heart.

7. taking your blood pressure reading

a. after applying the cuff and your body is in a comfortable
position, press the "Start" button. a beep is heard and
all display characters are shown for self-test. You can check
the LCD display according to the right picture. please contact
the service center if segment is missing.
b. If the monitor has stored results, the LCD will momentarily
display the most recent one. If no result has been
stored, zero will appear on LCD.
c. If the voice function is switched on, the monitor will
speak out measurement tips.
d. then the monitor inflates the cuff until sufficient
pressure has built up for a measurement.
ENGLISH
28