Voice Setting; Connecting The Cuff To The Monitor; Applying The Cuff - Gima KD-595 Manuel De L'utilisateur

27

3. voice setting

a. Voice language setting: In clock mode, you can select
the voice language by keeping on press the button "mEm".
now LCD blink "L0", "L1", "L2" ... "Ln" (n means the number
of language) circularly. "L0" represents closing voice function,
"L1" represents language 1, "L2" represents language 2, ...,
"Ln" represents language n, and so on. You can select
the wanted language by releasing button "mEm" when display
the corresponding language code.
b. If the number of language is only one, LCD will twinkle "on"
and "--" circularly. Here "on" represents opening the voice
function and "--" represents closing the voice function.
c. Voice volume setting: once you have selected a language,
keeping on pressing the button "mEm" again. a column of bar
will appear on the left side of the LCD. the higher the bars,
the louder the volume. release button "mEm" at your desirable
volume for confirmation.

4. connecting the cuff to the monitor

Insert the cuff tubing connector into the socket in the left
side of the monitor. make certain that the connector is
completely inserted to avoid air leakage during blood
pressure measurements.

5. applying the cuff

a. pulling the cuff end through the medal loop
(the cuff is packaged like this already), turn it
outward (away from your body) and tighten it
and close the Velcro fastener.
b. place the cuff around a bare arm 1-2cm above
the elbow joint.
c. While seated, place palm upside in front of you
on a flat surface such as a desk or table.
position the air tube in the middle of your arm in line
with your middle finger.
d. the cuff should fit comfortably, yet snugly around
your arm. You should be able to insert one finger
between your arm and the cuff.
ENGLISH