Over-Limit Indication; Limit Settings; Over-Limit Indication Sound Mute Setting; Packing List - Gima OXY 110 Manuel De L'utilisateur

63
Note: The oximeter is calibrated in the factory before sale, and there is no need for
user to calibrate again.

6 Over-limit Indication

6.1 Limit settings

• SpO low limit setting range: 50% ~ 99%.
2
• Pulse Rate limits setting range:
High: 100bpm--240bpm
Low: 30bpm--99bpm
During the measurement, if the measured value exceeds the preset value, the alert
beeping sound will be activated, the value that is over-limit will blink at the same time.

6.2 Over-limit indication sound mute setting

• During the measurement, if the global sound is enables, then short time press "
key to perform audible alert reset (that's to say, the alert sound will be mute, and icon
" " appears on the upper right corner of the screen), but the over-limited value
still keeps blinking. when the current alert event ends or a new type of alert event
occurs, then the status of audible alert reset will be ended (that's to say, the alert
sound can be generated when an alert event occurs, and icon "
upper right corner of the screen).
• When the global sound is enables, then the longtime pressing "
disable the global sound, and the sound icon becomes "
" " key again can enable the global sound.
Note: "
" means the speaker volume is set as 1 or 2 grid(s); "
speaker volume is set as 3 or 4 grids; "
or 6 grids.
• During the measurement, if the probe is off or disconnected, the message "Check
Probe" shows and keeps blinking on the display screen. The alert sound starts (in-
terval is 5 seconds). If the probe is still off and lasts for about 3 minutes, then the
Oximeter will power off automatically.

7 Packing List

1. An Oximeter
2. A SpO probe
2
3. User Manual
4. A oximeter rubber cover
5. A charging base
ENGLISH
" means the speaker volume is set as 5
" appears on the
" key cam
". Longtime pressing
" means the
"