Operation; Power On/Off The Oximeter - Gima OXY 110 Manuel De L'utilisateur

47
Nota:
• If the temperature probe detects a hardware failure, the display screen on the infra-
red temperature probe will show "Err" and will not enter into measurement mode.
• The infrared temperature probe will switch to standby state automatically if there is
no operation for 1 minute. If a further measurement is needed, press the measuring
key and repeat step 2 and step 3.
• Normal body temperature varies depending on the position/area the measurement
is taken from. The following table shows the varying temperature ranges of the dif-
ferent body positions.
Temperature varying range at different body positions:
Arm
Oral
Rectal
Ear
Safety Instruction for Temperature Measurement
 Do NOT take a measurement when the patient is moving.
 Patients with tympanitis or otitis problems should NOT use this device.
 When the infrared temperature probe is connected to the device, the probe will
consequently be at power-on status, therefore pressing the power on/off key on
the temperature probe will not cause any effect.

4 Operation

4.1 Power on/off the Oximeter

• Long pressing "
powered on. The oximeter will do self-test and then the software version and warn-
ing message "Professional attendance is required for continuous monitoring!" will be
shown on the screen, as shown in figure 4.1 (refer to your oximeter for actual version).
34,7 ~ 37,3°C
35,5 ~ 37,5°C
36,6 ~ 38,0°C
35,8 ~ 38,0°C
" Power/Left key for 1~2 seconds, then the oximeter will be
ENGLISH
Figura 4.1