Physiological Parameter Over-Limit Prompt - Gima CONTEC08A Mode D'emploi

67 ENGLISH
Note
When the [USER PREVIEW] is set to [ALL], , current user
can be switched under main interface; when set to a cer-
tain user, it will not be able to switch under main interface.
User type can be set to adult, pediatric and neonatal three
different kinds, setting method is as follows:
Chapter 9
OVER-LIMIT PROMPT FUNCTION
The Sphygmomanometer has two kinds of reminding methods: the technical parameter over-limit prompt and the physio-
logical parameter over-limit prompt.

9.1 Physiological parameter over-limit prompt

The sphygmomanometer has the function of over-limit prompt, the user can press [MENU] button to enter system menu,
select [PROMPT SETUP] option to enter its interface, then set the limit value of blood pressure. When the BP measurement
result is higher than the high limit or lower than the low limit and the prompt is ON, the physiological prompt will occur; in
[PROMPT SETUP] interface, select [SpO2 PROMPT] option to enter its interface, when the SpO measurement result is
2
higher than the high limit or lower than the low limit and the prompt is ON, the physiological prompt will occur.
In the state of physiological prompt, press any button to cancel the prompt and it does not affect the next prompt; the prompt
can be closed permanently with prompt switch of the prompt setup menu until the prompt switch be opened again.