Gima CONTEC08A Mode D'emploi page 90

Guidance and manufacturer's declaration – electromagnetic immunity – for all EQUIPMENT and SYSTEMS
Guidance and manufacturer's declaration – electromagnetic immunity
The device is intended for use in the electromagnetic environment specified below. The customer or the user of the
device should assure that it is used in such an environment.
Immunity test
Electrostatic discharge
(ESD) IEC 61000-4-2
Electrical fast transient/
burst IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short
interruptions and voltage
variations on power
supply input lines
IEC 61000-4-11
Power frequency
(50/60Hz) magnetic field
IEC61000-4-8
NOTE: U is the a.c. mains voltage prior to application of the test level.
T
ENGLISH
IEC 60601 test level Compliance level
±6 kV contact ±6 kV contact
±8 kV air ±8 kV air
±2 kV for power ±2 kV for power
supply lines supply lines
±1 kV differential ±1 kV differential
mode mode
±2 kV common mode ±2 kV common mode
<5% U (>95% dip <5% U
T
in U ) for 0.5 cycle in U
T
40% U (60% dip 40% U
T
in U ) for 5 cycles in U
T
70% U (30% dip 70% U
T
in U ) for 25 cycles in U
T
<5% U (>95% dip <5% U
T
in U ) for 5 sec in U
T
3A/m 3A/m
Electromagnetic environment - guidance
Floors should be wood, concrete or ceramic
tile. If floor are covered with synthetic mate-
rial, the relative humidity should be at least
30%.
Mains power quality should be that of a typi-
cal commercial or hospital environment.
Mains power quality should be that of a typi-
cal commercial or hospital environment.
(>95% dip Mains power quality should be that of a typi-
T
) for 0.5 cycle cal commercial or hospital environment. The
T
(60% dip device can continue the operation during
T
) for 5 cycles power mains interruptions due to the usage
T
(30% dip of battery.
T
) for 25 cycles
T
(>95% dip
T
) for 5 sec
T
Mains power quality should be that of a typi-
cal commercial or hospital environment.
90