Gima CONTEC08A Mode D'emploi page 77

77
• Please refer to related medical literature for detailed clinical restrictions and contraindications,
• This device is not used for treatment purpose.
• Do not use the SpO probe during MRI and CT scanning, as the induced current may cause burns.
2
• When the device is ON, if power interrupt for more than 30s, the SpO
stored, after the device is turned on, ensure that the SpO
• The probe can be used before/after sport, but not recommended to use during exercising.
Chapter 13
SpO MEASUREMENT METHOD
2
(This chapter is only suitable for European Union market)
1) Attach the SpO probe to the appropriate site of the patient finger as
2
the following figure.
2) Plug the connector of the SpO
switch to SpO interface. This operation brings no affection to other functions.
2
Note
SpO2 display range: 0% ~ 100%, PR display range: 30 bpm (beats/min) ~ 250 bpm (beats/min)
If the SpO works abnormally, after connecting the SpO
2
face or no data displayed under the SpO
Measurement Limitation
During operation, the accuracy of SpO
• High-frequency electromagnetic interference such as interference from electrosurgical apparatus connected to the sys-
tem.
probe cable into the USB socket in the lower right of the device. The main interface will
2
2
interface.
2
readings can be affected by:
2
ENGLISH
probe needs no operation after the power is re-
2
probe can be used normally.
2
probe to the device, the device will not switch to the SpO
Place SpO probe
2
inter-
2