Electromagnetic Compatibility Information - Gima KD-595 Manuel De L'utilisateur

electromagnetIc compatIBIlIty InformatIon

table 1
For all ME EQUIPMENt and ME SYStEMS
Guidance and manufacture's declaration - electromagnetic emissions
the KD-595 is intended for use in the electromagnetic environment specified
below. the customer or the user of the KD-595 should assure that it is used
in such an environment.
Emissions test
rf emissions
CISpr 11
rf emissions
CISpr 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
table 2
For all ME EQUIPMENt and ME SYStEMS
Guidance and manufacturer's declaration - electromagnetic immunity
the KD-595 is intended for use in the electromagnetic environment specified
below. the customer or the user of the KD-595 should assure that it is used
in such an environment.
IMMUNItY test
Electrostatic
discharge (ESD)
IEC 61000-4-2
power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
ENGLISH
Compliance
group 1
Class b
not applicable
not applicable
IEC 60601 Compliance
test level level
± 6 kV contact ± 6 kV
± 8 kV air contact
± 8 kV air
3 a/m 3 a/m
Electromagnetic environment - guidance
the KD-595 uses rf energy only for its internal
function. therefore, its rf emissions are very
low and are not likely to cause any interference
in nearby electronic equipment
the KD-595 is suitable for use in all
establishments other than domestic
and those directly connected to the public
low-voltage power supply network that
supplies buildings used for domestic purposes
Electromagnetic environment -
guidance
floors should be wood,
concrete or ceramic tile. If floors
are covered with synthetic
material, the relative humidity
should be at least 30%
power frequency magnetic fields
should be at levels characteristic
of a typical location in a typical
commercial or hospital
environment
34