Qlima Ronda 80 Manuel D'utilisation page 165

7. TECHNICAL SERVICE, ORIGINAL SPARE PARTS
Before any stove leaves the factory, it is first thoroughly tested and started up. Any
repairs or commissioning work that proves necessary during or after installation
must be carried out by a Qlima-approved heating technician. Original spare parts
are available exclusively from our Technical Service Centres and authorised sales
outlets.
Before contacting your dealer, the Technical Service Centre or the authorised heat-
ing technician make sure you have the model and serial number ready.
Only use original Qlima spare parts. The use of anything other than Qlima spare
parts will invalidate the warranty.
8 TROUBLESHOOTING
8.1 RESETTING AN ERROR
Before resetting an error, consult the error list (section 8.2) and follow the instruc-
tions. Reset the stove by pushing button 3 (see figure 2) on the display and holding
it down for 3 seconds.
If the error message reappears after resetting, consult your supplier.
8.2 ERROR LIST
PROBLEM CAUSE
Control panel No power supply to the
will not start stove
Printed circuit fuse has
blown
Control panel is defective
Ribbon cable is defective
Printed circuit board is
defective
Main switch is not turned
on
SOLUTION
Check that the stove is plugged in
Replace the fuse. Only to be done by a
Qlima-approved technician
Replace control panel. Only to be done by
a Qlima-approved technician
Replace the ribbon cable Only to be done
by a Qlima-approved technician
Replace the printed circuit board Only to
be done by a Qlima-approved technician
Turn the main switch on
4
165