Qlima Ronda 80 Manuel D'utilisation page 156

4.7 STANDARD SHUT-DOWN
4.
4.8 REMOTE CONTROL
ECONO SEND
ECONO SEND
TURBO
TURBO
ON 1 AUTO
OFF 1
ECONO SEND
AUTO
ON 1
ON 2 CANCEL OFF 2
TURBO
ON 2 CANCEL
AUTO
ON 1
ON 2 CANCEL
4
156
6. Select the desired differential value and then push button P3 to save the
setting.
7. The stove is now in Save mode and can be started up again.
DIFFERENTIAL TEMPERATURE
The differential temperature is the difference in degrees Celsius in relation to the
set temperature. Example: The set temperature is 20ºC and the set differential
temperature is 2ºC. The stove will now go out at a room temperature of 22ºC and
start up again at a temperature of 18ºC.
SWITCHING OFF SAVE MODE
1. Switch the stove off and repeat the above actions until "OFF" appears in the
display.
2. Then push button 3.
3. Save mode is now switched off.
To prevent excessive start-ups and shut-downs and extra wear on various parts, it
is recommended not to set the differential temperature at less than 2ºC or higher
than 4ºC.
The stove can be switched off by pressing button 3 until "OFF" appears in the dis-
play. During the shutdown phase, the supply of wood pellets to the combustion
chamber is stopped and the room air circulation blower is switched off. The smoke
extraction blower will continue to run for a short time, switching off after the
cooling-down phase.
How to use the remote control:
1. Point the remote control at the stove's control panel.
2. Check that there are no obstacles between the remote control and the sig-
nal sensor on the stove.
3. Each mode that can be selected using the remote control must be confirmed
with the button. An acoustic signal will sound after each selection to
ECONO SEND
TURBO
confirm the selected option.
ON 1 AUTO OFF 1
ON 2 CANCEL OFF 2
ON/OFF: Use this mode to switch the stove and the remote control on or off.
Hold the button down for at least 2 seconds to switch the system on or off.
Press to confirm.
ECONO SEND
TURBO
OFF 1
AUTO
ON 1 OFF 1
UP / DOWN: Use these buttons to set the desired temperature. The tempera-
OFF 2
ON 2 CANCEL OFF 2
ture can be set between 7ºC and 40ºC.
OFF 1
OFF 2
FAN: Select the desired speed
ECONO SEND
A = Automatic mode
TURBO
Speed 1 (on1)
Speed 2 (on2)
AUTO
ON 1 OFF 1
Speed 3 (on3)
ON 2 CANCEL OFF 2
Speed 4 (on4)
Speed 5 (on5)