Husqvarna 120iTK4-P Manuel D'utilisation page 14

• Cut large branches in sections so that you have
better control over where they fall. You should also
pay attention to the fact that falling branches can
bounce in the direction of the user after hitting
ground.
• Never cut through the swelling at the root of the
branch as this will slow down healing and increase
the risk of fungal attack.
• Use the stop at the base of the cutting head to
provide support during cutting. This will help prevent
the cutting attachment from bouncing on the branch.
• Make an initial cut on the underside of the branch
before cutting through the branch. This will prevent
tearing of the bark, which could lead to slow healing
and cause permanent damage to the tree. The cut
should not be deeper than ⅓ of the branch thickness
to prevent jamming. Keep the chain running while
you withdraw the cutting attachment from the branch
to prevent it jamming.
14
• Make sure you have a firm footing and that you can
work without being hampered by branches, stones
and trees.
WARNING:
trigger without having the cutting attachment
in full view.
To start the SavE function
The product has a SavE function. The SavE function
gives the longest operation time from the battery.
1. Push the SavE button. The LED comes on to show
that the function is on.
2. Push the SavE button again to stop the SavE
function.
To stop the product
1. Release the power trigger.
2. Push the stop button and then the green LED light
goes off.
3. Remove the battery from the product. Push the 2
release buttons and pull out the battery.
Never activate the power
707 - 008 - 06.04.2021