HBM C16i Série Notice De Montage page 24

24
With the C16i..., we recommend the use of EPO3/50t and C16/EPU44A or
C16/ZOU44A mounting accessories from HBM, because they permit easy
mounting. The rotation stop device welded onto the load cells and the dowel
pin provided are also suitable for this model type (see Dimensions =
Chapter 12).
Preparation work for mounting
When using EPO3/50t, C16/EPU44A or C16/ZOU44A to introduce and carry
off the load, the following preparations have to be made: A dowel pin is en-
closed in the packing for every load cell. This dowel pin and the rotation stop
welded onto the load cell prevent a potential transducer microrotation, thus
preventing the cable from being damaged. Use a hammer to drive in the
dowel pin until it rests in the load introduction part's pocket bore. Radially
position the open side of the dowel pin.
Position of rotation stop dowel pin:
ATTENTION
Radially position open side!
The bore depth ensures correct fitting of the pin. Only one load introduction
part per load cell must be equipped with this pin. This load introduction part
must be mounted below the load cell to enable the dowel pin to engage into
the rotation stop recess (see Dimensions = Chapter 12). No pin must be
introduced into the bore on the upper load introduction part.
Please also refer to and comply with the special notes at the end of this
chapter.
The areas or foundations below the lower load introduction part (for carrying
off the load) and above the upper load introduction part should be as even
and level as possible.
Practically drill the required borings for securing and fixing on the weighbridge
resp. tank and base plate before you mount the weighing platform. The di-
mensions for use with EPO3/50t and C16/EPU44A or C16/ZOU44A are as
shown in the dimensioned drawings in 12.
HBM
C16i...
or
A1461--1.2 de/en/fr