Anleitung_E_EAS_620_SPK7:_
GB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Handle under load
Vibration emission value ah = 3.36 m/s
K uncertainty = 1.5 m/s
2
Important!
The vibration value changes according to the area of
application of the electric equipment and may exceed
the specified value in exceptional circumstances.
Reduce noise generation and vibration to a
minimum!
Use only equipment that is in perfect condition.
Maintain and clean the equipment regularly.
Adopt your way of working to the equipment.
Do not overload the equipment.
Have the equipment checked if necessary.
Switch off the equipment when not in use.
Wear gloves.
8. Maintenance
8.1 Replacing the saw chain and cutter rail
The cutter rail needs to be replaced if
the guide groove of the cutter rail is worn;
Proceed as described in the section "Assembly of the
cutter rail and the saw chain".
8.2 Checking the automatic chain lubrication
You should check the operation of the automatic
chain lubrication system on a regular basis in order to
guard against overheating and the associated
damage to the cutter rail and the saw chain. To do
this, point the tip of the cutter rail towards a smooth
surface (board, section of a cut tree) and allow the
chainsaw to run. If an increasing oil trace becomes
evident during this process then the automatic chain
lubrication system is working properly. If no clear oil
trace is evident then please refer to the
corresponding instructions in "Troubleshooting". If the
information contained there still fails to remedy the
situation then please contact our service department
or another similarly qualified workshop. Important!
Do not actually touch the surface with the tip of the
cutter rail when performing this test. Keep a safe
distance (approx. 20 cm).
20
11.12.2009
9:51 Uhr
Seite 20
8.3 Sharpening the saw chain
Effective working with the chainsaw is only possible if
the saw chain is in good condition and sharp. This
also reduces the risk of kickback. The saw chain can
be re-sharpened by any dealer. Do not attempt to
sharpen the saw chain yourself unless you have the
necessary special tools and experience.
2
9. Cleaning and storing
Regularly clean the clamping mechanism by
blowing it out with compressed air or cleaning it
with a brush. Do not use tools for cleaning.
Keep the handles free of grease so that you can
maintain a firm grip.
Clean the equipment as required with a damp
cloth and, if necessary, mild washing up liquid.
If the chainsaw is not to be used for an extended
period of time then you should remove the chain
oil from the tank. Briefly immerse the saw chain
and the cutter rail in an oil bath and then wrap
them in oil paper.
Important!
Always disconnect the mains plug before
cleaning the chainsaw.
Never immerse the unit in water or other liquids in
order to clean it.
Store the chainsaw in a safe and dry place out of
the reach of children.
10. Notes on environmental protection
/ disposal
The equipment must be properly disposed of when it
reaches the end of its service life. Cut off the power
cable to prevent it being used by mistake. The
equipment must not be disposed of as domestic
waste. Instead, in the interests of the environment it
should be disposed of via a designated recycling or
disposal point for electrical equipment. Please
contact your local authorities for information about
proper disposal of the equipment in your area.
Packaging materials and worn accessory parts
should also be disposed of at the designated
recycling or disposal points.