General Safety Regulations; Layout And Items Supplied; Intended Use; Assembly - Ergo tools Pattfield E-EAS 620 Mode D'emploi D'origine

Anleitung_E_EAS_620_SPK7:_
GB
Packaging:
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled.
When using the equipment, a few safety
precautions must be observed to avoid injuries
and damage.
Read the operating instructions carefully and
comply with them. It is important to consult these
instructions in order to acquaint yourself with the
equipment, its proper use and the important
safety regulations.
Keep this manual in a safe place so that the
information is available at all times.
If you give the equipment to any other person,
give them these operating instructions as well.
We can accept no liability for damage or
accidents which arise due to non-compliance
with these instructions.

1. General safety regulations

Please refer to the booklet included in delivery for the
safety information.
CAUTION
Read all the safety information and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
This equipment is not designed to be used by people
(including children) with limited physical, sensory or
mental capacities or those with no experience and/or
knowledge unless they are supervised by a person
who is responsible for their safety or they have
received instructions from such a person in how to
use the equipment safely. Children must always be
supervised in order to ensure that they do not play
with the equipment.
16
11.12.2009 9:51 Uhr Seite 16

2. Layout and items supplied

1. Power cable
2. Cable strain-relief clamp
3. ON/OFF switch
4. Handle
5. Carrying strap
6. Additional handle
7. Bottom telescopic tube
8. Connecting piece
9. Top telescopic tube with motor housing
10. Oil tank
11. Oil tank cover
12. Saw chain
13. Cutter rail
14. Chain wheel cover
15. Thumb screw
16. Multifunction Tool
17. Cutter guard

3. Intended use

The chainsaw with telescopic handle is designed for
lopping off tree branches. The equipment is not
suitable for extensive sawing work, felling trees or
sawing any materials other than wood.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Assembly

Important! Do not connect the chainsaw to the
power supply until it has been fully assembled and
the chain tension has been adjusted. Always wear
protective gloves when working on the chainsaw to
protect yourself against injury.
4.1 Assembly of the cutter rail and the saw chain
Carefully unpack all parts and check that they are
complete (Fig. 1).
Undo the fixing screw of the chain wheel cover
(Fig. 2).
Take off the chain wheel.
Lay the chain as shown in the groove which runs
around the cutter rail (Fig. 3/item A).