Accessories; Standard Accessories - Hitachi G 12VE Mode D'emploi

English
CAUTION
● Repair, modifi cation and inspection of Hitachi
Power Tools must be carried out by a Hitachi
Authorized Service Center.
This Parts List will be helpful if presented with
the tool to the Hitachi Authorized Service Center
when requesting repair or other maintenance.
In the operation and maintenance of power tools,
the safety regulations and standards prescribed
in each country must be observed.
WARNING
Never use any accessories other than those mentioned below.
The use of any accessories other than those mentioned below or attachments not intended for use
such as cup wheel, cut-off wheel or saw blade is dangerous and may cause personal injury or property
damage.
NOTE
Accessories are subject to change without any obligation on the part of the HITACHI.

STANDARD ACCESSORIES

○ Depressed center wheel (Code No. 316821) .............................................................................................................1
4-1/2" (115 mm) external dia. × 1/4" (6 mm) thickness × 7/8" (22.23 mm) hole dia.
○ Wrench (Code No. 938332Z) .....................................................................................................................................1
○ Side Handle (Code No. 318312) .................................................................................................................................1
○ Hex. Bar Wrench 4 mm (944458) ...............................................................................................................................1
NOTE
Specifi cations are subject to change without any obligation on the part of the HITACHI.
14
MODIFICATIONS
Hitachi Power Tools are constantly being improved
and modifi ed to incorporate the latest technological
advancements.
Accordingly, some parts may be changed without
prior notice.

ACCESSORIES