Error Codes; Technical Data - IKA RV 8 Mode D'emploi

Error Codes

Any malfunctions during operation will be identified by an error message on the display.
Once a serious error message has been displayed, the lift moves to the top end position and the device can no longer be operated.
Proceed as follows in such cases:
- switch off device using the main switch,
- carry out corrective measures,
- restart device.
Error code Cause
E03 Temperature inside the device
is too high
E04 Target speed is not reached
Motor blocked
E09 Flash memory storage error
If the actions described fail to resolve the fault or another error code is displayed, then take one of the following steps:
- contact the service department,
- send the device for repair, including a short description of the fault.

Technical data

Operating voltage range
Rated voltage
Frequence
Rated power of RV8 device(without heating bath)
Rated power (max.) of switching adaptor
Speed
Speed tolerance
Speed display
Dimensions of visible display area (W x H)
Display
Smooth start
Lift
Stroke
Head angle adjustable
Cooling surface
Cooling water flow rate min.
Cooling water flow rate max.
Cooling water pressure max.
Perm. On-time
Perm. ambient temperature
Perm. relative humidity
Protection acc. to DIN EN 60529
Protection class
Contamination level
Weight (no glassware; no heating bath)
Dimensions (W x D x H)
Operation at a terrestrial altitude
Subject to technical changes!
Effect
Room temperature > 40°C
Load too large
Cable break
Transmission error
Set speed: < 100 rpm
Set speed: ≥ 100 rpm
Correction
- Switch off the device
- Let the device cool down
- Check the location (see Technical data)
- Reduce the volume in the evaporator
- Turn the unit off and on again
Vac (100 - 240) ± 10%
Vac 100 - 240
Hz 50 / 60
W 75
W 90
rpm 5 - 300
rpm ± 1
% ± 1
digital
mm 37 x 18
7 segments display
yes
manual
mm 120
0° - 45°
cm 1500
2
l/h 30
l/h 100
bar 1
% 100
°C 5 - 40
% 80
IP 20
I
2
kg 12.5
mm 595 x 390 x 615
m max. 2000
34