IKA RV 8 Mode D'emploi page 25

3.) Fix the Desktop switching. (Fig. 9)
• Attach the switching adapter (K) on the rear side. Secure it with
the Velcro, by contracting both tabs on the switching adapter.
The Velcro must not be below the switching adapter.
• Connect the Low-voltage connector (M) to the connection
socket (N). (Fig. 9)
• Plug the power cord (L) in the switching adapter and connect it
to the power source.
• Observe the valid supply voltage.
4.) Fix the Holding bracket (Fig.10)
5.) Insert the bottle and attach the supplied hose
connectors to the bottle. (Fig. 11)
6.) Adjust the angle of the rotation head. (Fig. 12)
• Remove the clamping device for the angle setting of the
K
rotation drive on the right side of the lift by rotating the knob
counterclockwise.
N
M
L
Fig. 9
7.) Set the drive at an angle of approx. 30°. (Fig. 13)
Fig.10
• Then, secure the rotary drive against rotation by tightening the
adjustable knob clockwise.
Fig.11
Fig.12
30°
Fig.13
25