Glassware - IKA RV 8 Mode D'emploi

Glassware

NOTE: Please read the operating instructions of the glassware for
the safe handling of laboratory glassware !
• Open the locking device (O) on the drive head by turning it 60°
counterclockwise. (Fig.14a)
See indication:
"CLOSE„
• Feed the vapour tube in until it stops.
• Then, lock the locking device (O) by turning it clockwise by 60°.
(Fig. 14b)
• The vapour tube is not allowed to be pulled out !
• Check the correct axial locking device on the vapour tube.
Fit & unfit the evaporation flask / push off mechanism
O
Fig.14a
Turn clockwise () for tight-fitting
Turn counterclockwise () for loosen tight-fitting
Mount the evaporation flask:
- Place the evaporation flask (R) on the Vapour tube. (Fig.15)
- Turn the plastic nut (P) with the clip (S) counterclockwise until
the clip can be put on the flange. (Fig. 16)
- Now turn the plastic nut clockwise until the clamp is hard up
O
against the flange. When doing so, hold the locking device (O)
on the steam pipe.
R
Remove the evaporation flask:
- Hold the locking device (O) and loosen the plastic nut by turning
Fig.14b
it counterclockwise. This releases a tightly clamped evaporating
flask.
- Hold the evaporating flask at the flange and open the jaws of
the clamp.
- Remove the evaporating flask.
- Check that the locking of vapour tube is still closed!
O
P
R
Fig.15
O
P
S
Fig.16
26