Accessories; Standard Accessories; Optional Accessories - Hitachi CM 5SB Instructions De Sécurité Et Mode D'emploi

(3) Remove the end of the pig-tail on the carbon brush
from the terminal section of brush holder and then
remove the carbon brush from the brush holder.
<Assembly>
(1) Insert the end of the pig-tail of the carbon brush in
the terminal section of brush holder.
(2) Insert the carbon brush in the brush holder.
(3) Use the auxiliary hexagonal wrench or small
screwdriver to return the edge of the spring to the
head of the carbon brush.
(4) Mount the tail cover and tighten the D4 tapping
screw.
Carbon Brush
holder
brush
WARNING:
NOTE: Accessories are subject to change without any obligation on the part of the HITACHI.

STANDARD ACCESSORIES

Wrench (Code No. 938332Z) .................................................................................................................................. 1
Side Handle (Code No. 994322) ............................................................................................................................. 1
Adapter (Code No. 320994) .................................................................................................................................... 1
OPTIONAL ACCESSORIES ........... sold separately
Diamond Wheel (Segment type) (Code No. 994325, 307007) ............................................................................. 1
Diamond Wheel (Wave shape type) (Code No. 994326) ..................................................................................... 1
NOTE: Specifications are subject to change without any obligation on the part of the HITACHI.
Spring
Fig. 8

ACCESSORIES

ALWAYS use Only authorized HITACHI replacement parts and accessories. NEVER use
replacement parts or accessories which are not intended for use with this tool. Contact
HITACHI if you are not sure whether it is safe to use a particular replacement part or
accessory with your tool.
The use of any other attachment or accessory can be dangerous and could cause injury
or mechanical damage.
5. Service and repairs
All quality power tools will eventually require
servicing or replacement of parts because of wear
from normal use. To assure that only authorized
replacement parts will be used, all service and
repairs must be performed by a HITACHI
AUTHORIZED SERVICE CENTER, ONLY.
6. Service parts list
CAUTION: Repair, modification and inspection
of Hitachi Power Tools must be
carried out by an Hitachi Authorized
Service Center.
This Parts List will be helpful if
presented with the tool to the
Hitachi Authorized
Service Center when requesting
repair or other maintenance. In the
operation and maintenance of
power tools, the safety regulations
and standards prescribed in each
country must be observed.
MODIFICATIONS:
Hitachi Power Tools are constantly being improved
and modified to incorporate the latest
technological advancements.
Accordingly, some parts (i.e. code numbers and/
or design) may be changed without prior notice.
English
11