Connection To The Audio System; Mains Connection - MC Crypt CMP-950RUSB Notice D'emploi

8. Connection to the Audio System

The player is equipped with OUTPUT RCA sockets (26) for each drive for connection to your audio system (e.g.
mixing desk).
To connect the outputs, use shielded cables only. The use of other cables might cause
interferences.
To avoid distortions or mismatches which could damage the device, only connect devices with
the same connection type.
For this, observe also the connection data in the section "Technical Data".
• Connect the OUTPUT 1 connections (26) to a free input of your mixing desk or pre-amplifier.
• Connect the OUTPUT 2 connections (26) to another free input of your mixing desk or pre-amplifier.
• Always connect the white socket to the left input and the red socket to the right input.

9. Mains Connection

The mains outlet to which the player is connected must be easily accessible to quickly separate
the device from the mains voltage in case of an error.
The player and all connected devices must be switched off when the power supply is
connected.
Make sure that all electrical connections and connection cables between the different devices
and any extension cables comply with the regulations and the operating instructions.
• Connect the small device connection plug of the power line to the power connection (27) on the device.
• Plug the power plug into a wall socket.
• Use the power switch (1) to switch the player on or off (when the switch is depressed, the device is turned on).
39