MC Crypt CMP-950RUSB Notice D'emploi page 44

10. Commissioning
l) Synchronisation of the Playback Speed
To mix or cross-fade two signal sources cleanly, the beats have to be synchronised in many cases.
This can be achieved in three ways:
• Using the PITCH slide control (13). It allows you to permanently modify the speed. This function is used when
two tracks have two completely different tempos.
• Using buttons PITCH BEND +/- (14 and 16). This allows you to change the speed temporarily. This function is
used when two tracks have the same beat but the starting point has to be synchronised.
• Using the jog wheel (2). By turning the wheel, you can change the speed temporarily. The speed change depends
on how quickly the jog wheel is turned. This function can also be used when two tracks have the same beat but
the starting point has to be synchronised.
To determine the beats per minute (BPM) of a title, press the TAP button (5) in the rhythm of the music. The display
(17) shows the beats per minute (BPM).
PITCH slide control
• Press the PITCH button (13) to activate the PITCH slide control (15).
• Modify playback speed by moving the PITCH slide control (13) up or down. The percentage of the speed change
is displayed. Put the slide control in centre position for original speed.
PITCH BEND buttons
• Hold down the PITCH BEND +/- (14 or 16) buttons during playback to change the speed.
The PITCH BEND - button (16) reduces the speed.
The PITCH BEND + button (14) increases the speed.
• The longer the PITCH BEND button is held down, to bigger the corresponding speed change.
• When the button is released, the music is played at original speed or at the speed specified by the PITCH slide
control (13).
44