Replacing The Plastics Insert; Replacing The Recuperating Spring; Transport; Storage - ATIKA BWS 600 Notice Originale

Pay attention to the correct running direction of the saw blade: The
arrow on the safety guard and the arrow on the saw blade must show to
the same direction.
8. Reinstall the front saw blade flange and the washer.
9. Secure the saw blade using the screw.
10. Slide the both washers (9) on the support pin (10).
11. Lift the tilt table and guide the support pin into the hole (A).
12. Install the cover plate (12) in its guide at the same time.
A second person may be required.
13. Plug the spring cotter pins through the support pin.
14. Remove the locking pin (13).

Replacing the plastics insert

Immediately replace the worn or damaged plastics inserts (18).
1. Loosen the screws of the plastics insert and remove them.
2. Insert a new plastic insert and screw it tightly in place.

Replacing the recuperating spring

Immediately replace a worn or damaged recuperationg spring.
1. Pull out the spring cotter pin (4). When doing so, firmly hold the tilt
table.
2. Slowly lower the tilt table towards the ground.
3. Remove the two washers (9) and the return spring (11).
4. Slide a new return spring and the two washers on the support pin.
5. Lift the tilt table and guide the support pin into the hole (A).
6. Install the cover plate (12) in its guide at the same time.
A second person may be required.
7. Plug the spring cotter pins through the support pin.

Possible faults

Before each fault elimination:
- Switch off device
- Wait unitl the saw comes to a stop.
Pull out power plug
-
After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after switching on
Jigging does not work
Machine stops while cutting
Burned spots at the cut areas
Saw vibrates
Recuperating mechanism of the jigging
device does not work
Decelaration too slow (time to dead stop
>10 sec.)
Possible cause
• Power failure
• Extension cable defect
• Motor or switch defect
• Safety hook is not released
• Saw blade blunt
• Feed is too great
• Saw blade blunt
• Saw blade is warped
• Saw blade not properly mounted
• Recuperating spring broken or worn out
• Brake defective
• Brake disk worn
• Different causes

Transport

Remove mains plug before each transport.
Before each transport:
1. Push the tilt table towards the saw blade.
2. Turn down the safety hook until it engages.
Transport: Hold the handle (14), put one foot onto the axle and
tilt the firewood saw towards your body.
In this position, it is easy to move the saw.
Putting down: Put one foot onto the axle and carefully put down
the firewood saw.

Storage

Pull out power plug
Store unused equipment in a dry, locked place out of the reach of
children.
Before a longer period of storage carry out the following to extend the
saw service life and ensure an easy operating:
− thoroughly clean the device
− treat all movable parts with an environmentally friendly oil
Never use any grease!

Guarantee

Please observe the enclosed terms of guarantee.
Remedy
• Check the fuse.
• Check cable, no longer use defect cable
• Have motor or switch checked by an approved
electrician or replaced by original spare parts
• Release the safety hook (3).
• Replace saw blade or have it sharpend
• Allow motor to cool and proceed working with less
pressure
• Replace saw blade or have it sharpend
• Replace saw blade
• Mount saw blade properly
• Replace the recuperating spring
• Switch checked by an approved electrician or replaced
by original spare part
15