2/ Installing Your Appliance; Choice Of Location; Fitting - De Dietrich DTE1111W Guide D'installation Et D'utilisation

2 2 / / INSTALLING YOUR APPLIANCE
Fig. 01
• • CHOICE OF LOCATION
Your appliance shoud be flush mounted in the
surface of a support cabinet that is a minimum
of 3 cm thick, made of a material that resists
heat or that is covered with such a material.
If a horizontal divider wall is positioned under
the hob, it should be placed between 10 cm
and 15 cm away from the top of the work sur-
face. In any event, do not store aerosol cans or
containers under pressure in any compartment
that may exist under the hob (see " Safety Rec-
ommendations " chapter).

FITTING

• •
Follow the diagram (Fig. 01).
— — Remove the pan supports, the burner cov-
ers and burner heads; noting their positions.
— Turn the hob over and place it carefully over
the opening so as not to damage the knobs or
spark igniters.
— To ensure a tight seal between the housing
and the worktop, stick the foam seal a a l l o o n n g g t t h h e e
e e x x t t e e r r i i o o r r e e d d g g e e o o f f t t h h e e h h o o u u s s i i n n g g before installing
the hob (Fig. 02).
Total
dimensions
a a b b o o v v e e
the work
top
Total
dimensions
b b e e l l o o w w
the work
top
Housing
Seal
Fig. 02
29
APPLIANCE
Width Deep Thick
58 cm 52,2 cm 4,9 cm
55,4 cm 47,4 cm 3,5 cm
EN