3 3 / / USING YOUR APPLIANCE
LIGHTING THE HOB
• •
The burner safety measure is a metal rod
located directly to the side of the flame.
Each burner is controlled by a tap fitted with
a safety system that, in the event of acciden-
tal flame extinction (spills, draughts, etc.),
quickly and automatically cuts the gas supply
and prevents it from escaping.
Each burner is supplied by a tap which can be
opened by pressing it and turning it in a coun-
terclockwise direction.
O O
Le point "
" corresponds to a closed tap.
Choose the desired burner by using the sym-
bols located near the knobs (e.g.: right rear
burner
).
To light the burner:
— Press the knob and turn it a counterclock-
wise direction
Continue pressing on the knob to produce a
series of sparks until the burner lights.
The setting for more moderate flame intensi-
ties is between the
symbol. .
to the maximum setting
symbol and the
Fig. 01
Tip
.
— If the flame goes out accidentally,
reignite normally following the lighting
instructions.
— The burner's flames are smaller near the
support to protect the support's enamel.
— The noise made by certain burners is
related to their high power and to gas
combustion; it does not alter cooking
quality.
— In the event of a power cut, place a
lighted match near an open burner.
Warning
— Hold the knob fully pressed down
for a few seconds after the flame appears in
order to trigger the safety system.
39
EN