Installing Your Appliance; Installation - De Dietrich KIP711W Guide D'installation Et D'utilisation

9964 2283_A_ML.qxp 18/04/2007

1 / INSTALLING YOUR APPLIANCE

EN
As shown in this logo, the materials used to package this appliance are not recycla-
ble. Recycle them and play a role in protecting the environment by depositing them
in municipal containers provided for this purpose.
Recycling of the appliances organised by your manufacturer will thus be undertaken
in optimum conditions, in accordance with European directive 2002/96/CE relating
to electrical and electronic equipment waste. Contact your local authority or retailer
for how to have used appliances collected or collection points.
6,4

Installation

Your appliance should be positioned so that
the mains switch is accessible.
The distance between the edge of your appli-
ance and the side and rear walls (or parti-
tions) must be at least four centimetres (area
A).
Your appliance can be easily integrated above
a cabinet, an oven or a build-in household
appliance. Simply verify that the air intakes
and outlets are well clear.
Stick the foam gasket to the bottom of your
appliance. This will allow you to achieve an air-
tight seal with the worktop.
Attach the clips to the hob. (See drawing)
10:58 Page 18
L L
l' '
L L ' '
Tip
If your hob is located above your
oven, the hob's thermal safety measures
forbid the simultaneous use of the hob and
your oven's pyrolysis program (self-clean-
ing by extreme heat).
This safety feature can be activated, for
example, when the hob is installed over an
oven that is not sufficiently insulated. If this
occurs, a series of small lines appear in the
control panel. In this case, we recommend
that you increase the ventilation of your hob
by creating an opening in the side of your
cabinet (8 cm x 5 cm) and/or that you install
the oven insulation kit (reference 75X1652)
that is available from the After-Sales
Service Department.
18
l