Folding Back The Bicycle Carrier - EUFAB PREMIUM TG Manuel De L'opérateur

Figure 23: Attaching the front wheel of the 2nd bicycle
Figure 24: Attaching the back wheel of the 2nd bicycle
WARNING!
Personal injury or property damage due to loss of
bicycles.
Driving without the safety strap can lead to accidents. The
bicycle carrier may not be used without this safety strap.
• Before setting off, check the correct and firm positioning of
the safety strap around the bicycles and U-shaped bracket of
the carrier (Figure 25).
• Before embarking on any journey, check the correct and firm
positioning of both straps around the front wheel and the
strap around the back wheel of the bicycle.
• If necessary tighten the straps again.
• Before embarking on any journey, check to make sure the
straps used are undamaged and not worn.
18
• Damaged or worn straps must be replaced with undama-
ged ones before you embark on your journey. Only straps
authorised by EAL GmbH for this purpose may be used.
Figure 25: Applying the safety strap
WARNING!
Personal injury or material damage due to loss of a
bicycle while driving.
A loose connection between the bicycle carrier and the bicycle
can lead to the detachment of the connection and loss of the
bicycle.
• Check that the bicycles are securely and fully mounted.
• If one of the fastenings is loose, repeat the steps shown in
Figures 16 to 25.
NOTE
The frame holder may result in minor pressure points on the
bicycle frame and damaged to the paintwork. Protect the
bicycle frame, for example, using protective film

5.7 FOLDING BACK THE BICYCLE CARRIER

BEWARE!
Property damage due to opening the boot lid.
The boot lid could hit the bicycle carrier and be damaged.
• Switch off the electric boot lid release, and operate it
manually.
• Fold up the bicycle carrier before opening the boot lid.
Figure 26: Opening the boot lid