Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. Safety precautions
• The warning triangle labels all instructions important to safety. Always follow these otherwise you could injure yourself or
damage the device.
• Children may not play with the device.
• Cleaning and user maintenance may not be carried out by children without supervision.
• Do not treat packaging material carelessly. This may become a dangerous plaything for a child!
• Only use this product for its designated purpose!
• For your own safety, only use accessories and spare parts that are stated in these instructions or that are recommended by
the manufacturer!
• The fixtures are to be adapted to the properties of the relevant wall, if necessary obtain specialist advice!
• When drilling, make sure that any pipes or cable in the wall are not damaged!
• Make sure that the material or the wall (e.g. masonry, plaster, wood) is capable of carrying the permitted maximum weight.
Unsuitable options are, for example, dry walls or walls with wood cladding.
• The maximum payload of 30 kg may not be exceeded!
• Attach the wall mount at an easily accessible height!
• When drilling the holes, wear goggles.
5. Operating instructions
5.1 Overview
1.
Base plate
2.
Ball-neck
3.
Hexagonal screw with spring washer
and washer
4.
Screws and dowels
5.2 Assembling the wall mount
Insert the hexagonal screw, Position 3 in the overview, through the spring washer and washer, and then
from the rear of the base plate, Position 1 in the overview, through the hole in the middle of the base plate.
Position the ball-neck, Position 2 in the overview, with the threaded hole on the hexagonal screw. Turn the
screw a few times to secure. Position the ball-neck so that the pin on the base is located in the small drilled
hole in the middle of the base plate. Tighten the hexagonal screw firmly.
5.3 Mounting to the wall
Mark the positions for the holes to be drilled at the appropriate location on the wall. To do this, hold the wall mount up against the wall
with the type plate facing upwards (the hexagonal screw on the rear must protrude over the hole for the pin, Figure 3). Mark the holes of
the base plate on the wall.
Drill a hole at the marked positions. Remove drilling residue from the hole.
Insert the dowel into the hole. Position the wall mount over the holes in the wall. Insert the screws through the holes of the wall mount
into the dowel holes. Now screw the wall mount firmly in place.
Before using the product for the first time, always check to ensure the safe hold of the wall mount.
5.4 Securing the bicycle rack to the wall mount
Open up the closure on your bicycle rack. Place the bicycle rack with the closure on the ball of the wall mount. Push the bicycle rack against
the wall mount and close the closure again.
Check to ensure that the bicycle rack is securely fitted to the wall mount.
Figure 2: Overview
Figure 3: Base plate rear
Top
5
Publicité
Table des Matières
