Adjustment Of The Quick Lock; Connecting The Electrical Cable; Mounting The Bicycles Onto The Carrier - EUFAB PREMIUM TG Manuel De L'opérateur

5.4 ADJUSTMENT OF THE QUICK LOCK

Only do this if the bicycle carrier cannot be mounted firmly to the trailer
tow bar, as described in section 5.3, "Mounting the bicycle carrier onto the
trailer tow bar".
• Remove the bicycle carrier from the trailer tow bar as described in Section
5.8, "Removing the bicycle carrier from the trailer tow bar"
• Loosen the lock nut a little (Figure 15).
• Screw in the setting screw one quarter of a turn (Figure 15).
• Tighten the locking nut (Figure 16).
• Check that the carrier is now firmly positioned on the trailer tow bar, as
described in "Mounting the bicycle carrier onto the trailer tow bar". If not,
repeat steps described above.
Figure 15: Adjustment of the quick lock
Figure 16: Adjustment of the quick lock

5.5 CONNECTING THE ELECTRICAL CABLE

Insert the plug of the electrical cable of the bicycle carrier into the mains
socket of your vehicle. Read the instructions for your vehicle or tow bar.
WARNING!
Personal injury due to not being seen by other road
users.
Driving without a functioning lighting system can lead to
accidents.
• Check the correct operation of the lighting system before
each trip.
• Replace any defective bulbs if necessary.
• Check the connection between the plug and tow bar.

5.6 MOUNTING THE BICYCLES ONTO THE CARRIER

BEWARE!
Personal injury or material damage possible due to
flying parts.
Improperly tightened parts on the bicycles can become loose
while driving.
• Remove all parts not firmly attached to the bicycle, such
as e-bike batteries, the air pump, the cycle bag, the bicycle
case or navigation devices.
NOTE
In order to improve the performance of your vehicle, mount
the heaviest bicycle first. If carrying only one bicycle, this
should be mounted in the rail closest to the boot of the
vehicle.
16
NOTE
The frame holders can be placed anywhere on the bike or
on the U-shaped bracket. Since the frame holders are not
tied to any specific position, you may try out a number of
positions. During initial assembly, take time to find the best
and most stable position. It is important to attach the frame
holder as high up as possible, so that maximum stability can be
achieved.
Figure 17: Adjusting the frame holder
Figure 18: Opening the wheel stoppers