STERWINS EHT2-60.4 Notice De Montage, Utilisation Et Entretien page 183

Les langues disponibles

The declared vibration and noise total value has been measured in accordance with a

standard test method and may be used for comparing one tool with another. The declared

vibration total value may also be used in a preliminary exposure assessment. The vibration

emission and noise during actual use of the power tool can differ from the declared total value

depending on the ways in which the tool is used; and it may be necessary to identify safety

measures to protect the operator that are based on an estimation of exposure in the actual

conditions of use (taking into account all parts of the operating cycle such as the times when

the tool is switched off and when it is running idle in addition to the trigger time).

3. ASSEMBLY

WARNING! THE PRODUCT MUST BE FULLY ASSEMBLED BEFORE

OPERATION! DO NOT USE A PRODUCT THAT IS ONLY PARTLY

ASSEMBLED OR ASSEMBLED WITH DAMAGED PARTS! FOLLOW

THE ASSEMBLY INSTRUCTIONS STEP-BY-STEP AND USE THE

PICTURES PROVIDED AS A VISUAL GUIDE TO EASILY ASSEMBLE

THE PRODUCT !

3.1 UNBOXING

• WEAR GLOVES WHEN UNBOXING.

• DO NOT USE CUTTER, KNIFE, SAW OR ANY OTHER SIMILAR TOOL FOR

UNBOXING.

3.2 INSTALLATION

Install the front handle : illustration 2.1 and 2.2

Align and push the handle in the space provided for this purpose. Put the screw with a

screwdriver. Tighten the screws securely.

3.3 PREPARATION

Blade cover : illustration 3.1

Remove the blade cover from the blade before operation. Align and push the blade cover onto

the blade to attach it.

• CARRY THE TOOL ONLY BY THE HANDLE (4 & 1). KEEP THE BOX FOR

FURTHER REUSE (TRANSPORT AND STORAGE).

• KEEP INSTRUCTION MANUAL IN A DRY AREA FOR FURTHER CONSULTATION.

183

1. Front handle

2. Hand safety switch

3. Switch trigger

4. Rear handle

5. Guard

6. Cable strain relief

7. Opening

8. Blade

9. Blade cover

10. LED Indicator