Proper Use; Unpacking - IKA IKAMAG RET control-visc C Mode D'emploi

• When using PTFE-coated magnetic bars, the following hase to
be noted: Chemical reactions of PTFE occur in contact with mol-
ten or solute alkali metals and alkaline earth metals, as well as
with fine powders of metals in groups 2 and 3 of the periodic
system at temperatures above 300 °C - 400 °C. Only elementary
fluorine, chlorotrifluoride and alkali metals attack it; halogenated
hydrocarbons have a reversible swelling effect.
(Source: Römpps Chemie-Lexikon and "Ulmann", Volume 19)
For protection of the equipment
• The appliance may only be opened by experts.
• The voltage stated on the type plate must correspond to the mains
voltage.
• Do not cover the device, even partially e.g. with metallic plates
or film. This results in overheating.
• Ensure that the base plate is kept clean.
• Protect the appliance and accessories from bumps and impacts.
• Only use glass encapsulated temperature sensors for electroly-
sis procedures.
• Observe the minimum distances between the devices, between
the device and the wall and above the assembly (min. 800 mm).
>100 mm >100 mm
28
3
• Use
-
• Range of use
- Laboratories
- Schools
- Pharmacies
This device is suitable for use in all areas except:
- Residential areas
- Areas that are connected directly to a low-voltage supply network
that also supplies residential areas.
4
Please unpack the equipment carefully and check for any
damages. It is important that any damages which may have ari-
sen during transport are ascertained when unpacking. If appli-
cable a fact report must be set immediately (post, rail or for-
warder).
The delivery scope covers:
an IKAMAG RET control visc /C, an operating instructions, an
main cable and a short instruction.
>100 mm

Proper use

For mixing and/or heating liquids

Unpacking

RETCV_0107