Table des Matières
Publicité
5
Commissioning
Check whether the voltage specified on the type plate mat-
ches the mains voltage available. The power socket used must
be earthed (protective earth conductor contact). Insert the
temperature measuring sensor (not included in the supply
schedule) into the 5-polar DIN-bushing at the rear of the instru-
ment. Put a magnetic bar into a vessel that is permeable for
magnetic field lines, and fill the vessel with the medium to be
processed. Put the vessel on the heating plate and immerse
the temperature measuring sensor into the medium (min.
20mm). Wit the enterprise without external temperature mea-
suring sensor see chapter 11.3. If these conditions are met,
the device is ready to operate after plugging in the mains plug.
If these procedures are not followed, safe operation cannot be
guaranteed and/or the equipment may be damaged.
Observe the ambient conditions (temperature, humidity, etc.)
listed under Technical Data.
6
Control elements
foil key Mode
foil key
Visc
LED Temp
RETCV_0107
digital display
foil key Temp
LED Mot
rotary knob Temp
rotary knob Mot
Mains switch
I
ll. 1
7
Display
When the functions are switched off, the digital display always
shows the set speed value.
real value
foil key Mot
PC-control
Pt 100 or
Pt 1000
In all three modes of operation only function "heating" has
been started, the display shifts to rated and real temperature.
In all three modes of operation only function "stirring" has
been started, the display shifts to rated and real speed.
e.g. phys. unit,
rated value
mode of operati-
Set value
Process value; (real value)
(rated value)
function started
on, error
code
mode of
operati-
on B or
C
29
Publicité
Chapitres
Table des Matières
