Safety Instructions; Proper Use - IKA MTS 2/4 digital Mode D'emploi

Contens
Guarantee

Safety instructions

Proper use

Unpacking
General information
Commissioning
Motor protection
Error codes
Maintenance and Cleaning
Associated standards and regulations
Technical data
List of spare parts MTS 2/4 digital
Spare parts diagram MTS 2/4 digital
Safety instructions
When adjusting the speed, pay careful attention to the con-
tainers fastened onto the agitation table to prevent the medi-
um to be shaken from possibly splashing out. Select the
speed based on how full the container will be so as to
prevent the medium from splashing out. Observe appli-
cable safety instructions and guidelines as well as work
protection and accident prevention requirements for use
in the laboratory. Avoid bumping and striking the agitati-
on table. Even minor damage that cannot be detected
may result in damage to the motor bearing. Careful hand-
ling will ensure safe working and a long service life for
the device.
If you notice that the device is not running smoothly, the
speed must always be reduced until no more unevenness
occurs in the operation.
8
Make certain that the device is equipped with at least
two diagonally offset or four micro-titer plates,
whether or not
Page
these are complete-
ly filled. Never ope-
2
rate the device
8
without micro-titer
8
plates. Otherwise,
9
resonance may
9
arise when it runs
10
at high speeds.
11
The micro-titer pla-
11
tes used for the agitation process must be securely
12
fastened on the agitation table. Make certain in this
12
regard to lock the round band for clamping the micro-
12
titer plates. It must be replaced when necessary befo-
18
re it is too worn.
19
Only a specialist may open the device.
ATTENTION! Covers or parts that can be removed
from the device must be put in place on the device in
order tro ensure safe operation.
The IKA MTS 2/4 digital was not constructed for operation in dan-
gerous atmospheres, for mixing dangerous substances or for
operation under water.
The instrument may not be operated in rooms with explosion
hazards. The device must be places on a level and skid-
free holding surface.
Use only original IKA accessories.
Proper use
The IKA MTS 2/4 digital is designed for agitating from
two to four micro-titer plates.
MTS 012002