Delta Q MILKQOOL Manuel D'utilisation page 66

EN INSTRUCTIONS AND MODE OF USE
66
A. B. C.
A. C.
B.
Fig. 18: Programming the tea
extraction button.
Programming the tea extraction button.
Note: The pre-defined factory volume for the tea extraction button is
around 180cc.
• T o alter the volume of your drink, ensure the machine is ON (see Fig.5),
check whether there is any water in the water tank and wait until the
control panel buttons indicate "Ready to use" (see Fig. 7).
• Then press the tea extraction button until the indicator lights of the
espresso and the coffee extraction buttons start blinking.
D.
Press the tea extraction button (see Fig. 18).
The indicator lights of the espresso and the long coffee extraction
buttons go out.
D.
Note: If the user does not press again the tea extraction button after 1 minute,
the equipment will revert automatically to the "Ready to use" mode.
• As soon as extraction has reached the desired dosage, press the tea
extraction button again and the operation is complete.
The equipment memorises this volume and will start extracting it until
new programming has been defined.
• After completing extraction, the equipment returns to "Ready to use"
mode (see Fig. 7).
Note: If the user fails to press the extraction button to complete the
operation, the equipment will automatically assume the maximum
volume of 200cc.